Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cleaning and care (Continued)
•
Before cleaning, detach the rubber brushes from the rotating brush,
the gasket and rubber plug from the juicing bowl.
(Rubber plug cannot be separated.)
•
Wash with diluted dish soap (neutral) and a soft sponge,
then rinse thoroughly with w ater and dry well.
• Use the tip of cleaning brush handle to clean the spouts of the juicing bowl.
(The inner surfaces may be scratched if you use the cleaning brush to clean it.)
•
After drying all the parts, assemble them correctly.
Do not leave them unassembled. (Otherwise there is a risk o f loss,
choking on and swallowing o f little parts by children, product failure, or leakage o f juice.)
■ R u b b e r b ru s h e s
c
To detach
Push the rubber brush to the direction
indicated by the arrow m ark and take the
part out from the gap.
( N ote
) Do not pull the rubber brush hard.
■ G a s k e t
• Gasket is located in the centre o f the juicing bowl (inner side).
C
To detach
Pull the gasket up.
■ R u b b e r p lu g
Pull the rubber plug out in the direction of the arrow.
•
Cannot be removed from the juicing bowl.
GB20
MHcrpy^MM Ha cawre Panatex.com.ua
R o ta tin g b ru s h / J u ic in g b o w l
• Rubber brushes are located at the side o f the rotating brush.
D
all the way up / down both ends.
C
D
Push the gasket into opening as figure below.
• Rubber plug is located on the outer bottom o f the juicing bowl.
Push the rubber plug into the opening in the
direction of the arrow until there is no gap.
NOT dishwasher safe
C
To attach
Insert the upper / lower grooves o f the
rubber brush into the gap and then slide it
•
To avoid dam aging the brush, make
sure the upper and lower grooves are in
the correct position.
Gap
Upper
(Long)
Lower
(Short)
To attach
♦
D
Insert the groove to
the projected part.
»
0
Top view
J
Sectional view
Werbung
Inhaltsverzeichnis
