Introduction; Device Description (Fig. 1) - Scheppach DP16SL Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope that your new device brings you much enjoy-
ment and success.
Note
In accordance with the applicable product liability laws,
the manufacturer of the machine assumes no liability
for damage to the machine or caused by the machine
arising from:
• Improper handling.
• Failure to comply with the operating instructions.
• Repairs carried out by third parties, unauthorised
specialists.
• Installing and replacing "non-original spare parts".
• Application other than specified.
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113/VDE 0113 not being observed.
Please consider:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description (Fig. 1)

1. Base plate
2. Drilling table holder
3. Adjustment handle for height adjustment
4. Toothed rack column
5. Column
6. Screw
7. Ring
8. Machine head
9. Handle
10. Depth stop
11. knurled nut
12. Stop
13. Engine
14. Belt guard
15. Locking screw
16. Chuck guard
17. Slotted screw
18. Drilling table
19. Angle scale
20. Screw 90° attachment
21. Clamping handle for height adjustment
22. Clamping screw for drilling table
23. Sprocket chuck
24. On/off switch
25. Laser ON/OFF switch
26. Chuck key
27. Spring cap
28. Groove
29. Outer nut
30. Inner nut
31. Notch
32. Hub
33. Spindle
34. Lock nut
35. Screw
36. Drive belt
37. Wing screw
38. Pulleys
www.scheppach.com GB | 27