Replacing Carbon Brushes; Switch Trigger; Chain Catcher; Instructions For Periodic Maintenance - Makita DUC252 Bedienungsanleitung

Replacing carbon brushes

Fig.43
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Fig.44
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Storing tool
Clean the tool before storing. Remove any chips and
sawdust from the tool after removing the sprocket cover.
After cleaning the tool, run it under no load to lubricate
the saw chain and guide bar.
Cover the guide bar with the guide bar cover.
Remove oil from the oil tank to empty it and place the
chain saw.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
Operating
time
Item
Inspection.
Cleaning.
Chain saw
Check at authorized service
center.
Inspection.
Saw chain
Sharpening if necessary.
Inspection.
Guide bar
Remove from the chain
saw.
Check the function.
Have it inspected regularly
Chain brake
at authorized service center.
Chain lubrication Check the oil feed rate.

Switch trigger

Inspection.
Lock-off button Inspection.
Oil tank cap Check tightness.

Chain catcher

Inspection.
Inspection.
Screws and nuts
014804
All manuals and user guides at all-guides.com

Instructions for periodic maintenance

To ensure long life, prevent damage and ensure the full
functioning of the safety features the following
maintenance must be performed regularly.
Warranty claims can be recognized only if this work is
performed regularly and properly. Failure to perform the
prescribed maintenance work can lead to accidents!
The user of the chain saw must not perform
maintenance work which is not described in the
instruction manual. All such work must be carried out by
authorized service centre.
Before
operation
16
Every Every 3
Everyday
week month
Before
Annually
storage