Safety And Warning Information - Genius Julietti Plus Bedienungsanleitung

1

Safety and warning information

Please read these Instructions for Use carefully
„
and only use your product as described in the
Instructions for Use to avoid injuries or material
damage.
Check the set before using it for the first time to
„
ensure that it is complete and no damage has
occurred in transit.
GB
The device is not intended for use by adults
„
or children with limited physical, sensory or
intellectual abilities or little experience with
household equipment, unless they are super-
vised by a competent person who is responsible
for their safety or they receive clear instructions
from such a person about how the device is to
be used.
Do not use the device if it is damaged in any
„
way. There is a serious risk of injury.
Do not make any unauthorised modifications,
„
repairs or changes to the device.
The Julietti Plus in practical use
 Fit the cutting base on to the collecting container so that it audibly locks.


6
Dispose of the packaging material properly.
„
When giving the product to a third party, always
„
also pass on these Instructions for Use.
Never place it on a hot surface or close to an
„
open flame.
Use the device only with the accessories pro-
„
vided, otherwise you will damage the device.
Never allow hands, hair, loose clothing or other
„
items to come into contact with the blades.
The device is only for private use and not for
„
commercial use.
Keep the product out of the reach of children.
„
There is a serious risk of injury.
Your Turbo Peeler has extremely sharp blades.
„
Never touch them with your hands!
Make sure that the blade you are not using al-
„
ways has a protective cover on it!
Never let children use the Turbo Peeler unsuper-
„
vised because of the risk of injury!
Place the frame of the Julietti Plus into the bottom section of the cutting
base so that the slightly rounded narrow side of the frame rests in the
corresponding recess in the bottom section of the cutting base. Then press
down the other side of the frame until it also locks.
You can now fit the spiral insert you want to use in the frame. Screw it in
clockwise until the insert locks. For best results, the blade should point
downwards when it has been fitted. Also check the marks on the frame
and spiral insert. Your Julietti Plus is now ready for use.