Technical Data; Safety Instructions - Milwaukee AG 8-100 Originalbetriebsanleitung
Winkelschleifer
Vorschau ausblenden
Andere Handbücher für AG 8-100:
- Gebrauchsanleitung (43 Seiten) ,
- Originalbetriebsanleitung (51 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TECHNICAL DATA
Angle Grinder
....... 750 W .............. 750 W ............ 750 W .................850 W ................850 W
Output
....... 410 W .............. 410 W ............ 410 W .................495 W ................495 W
... 10000 min
....... 100 mm ............ 115 mm .......... 125 mm...............125 mm .............125 mm
..... M 10 ................ M 14 .............. M 14 ...................M 14 .................M 14
........ 1,8 kg ............... 1,8 kg ............. 1,8 kg ..................1,8 kg ................1,8 kg
......... 89 dB(A) .......... 89 dB(A) ......... 89 dB(A) .............89 dB(A) ............89 dB(A)
....... 100 dB(A) ........ 100 dB(A) ...... 100 dB(A) ...........100 dB(A) ..........100 dB(A)
........... 7 m/s
h
........ 1,5 m/s
........... 3 m/s
h
........ 1,5 m/s
SAFETY INSTRUCTIONS
provided with this power tool.
power tool.
tool.
18
ENGLISH
AG 8-100
AG 8-115 (X)
AG 8-125 (X)
AG 9-125 XE
-1
-1
-1
...... 10000 min
.... 10000 min
2700-10000 min
2
2
2
............... 7 m/s
.......... 7,5 m/s
................10 m/s
2
............ 1,5 m/s
2
.......... 1,5 m/s
2
...............1,5 m/s
2
............... 3 m/s
2
.......... 3,5 m/s
2
...............3,5 m/s
2
............ 1,5 m/s
2
.......... 1,5 m/s
2
...............1,5 m/s
Just
l) Never lay the power tool down until the accessory has
AG 9-125 XC
n) Regularly clean the power tool's air vents.
-1
-1
........10000 min
p) Do not use accessories that require liquid coolants.
2
2
..............10 m/s
2
.............1,5 m/s
2
2
.............3,5 m/s
2
2
.............1,5 m/s
2
d) Use special care when working corners, sharp edges
selected wheel.
wheel is exposed towards the operator.
cut.
rotating wheel.
occur.
d) Do not restart the cutting operation in the workpiece.
cut.
a) Do not use excessively oversized sanding disc paper.
Kickback will propel the tool in
sanding paper.
Corners,
even during ordinary operation. Do not overstress the
with the guard.
Proper
Large workpieces
The wire
ENGLISH
19
Werbung
Inhaltsverzeichnis
