Troubleshooting Schedule - Husqvarna DE 110i Bedienungsanweisung

Troubleshooting schedule

Problem
The motor stops immediately af-
ter start or does not start.
The motor is on but there is no
suction.
The suction is not sufficient.
22
Troubleshooting
Cause
There is no power.
There is a fault with the battery.
The green LED flashes on the battery.
The HEPA filter is damaged or not installed.
There is a short circuit in the product.
Too high voltage in power supply.
Too high ambient temperature.
Fan is broken or disconnected.
The dust extraction hose is not connected cor-
rectly.
The dust extraction hose is blocked.
There is no Longopac.
The Longopac is not closed down with a cable
tie.
Too low voltage in power supply.
There is a hole in the dust extraction hose.
The prefilter is clogged.
The HEPA filter is clogged.
The top cover is loose.
The seals are broken
Solution
Connect the battery to the prod-
uct.
Do a check of the battery or re-
place the battery if necessary.
Let an approved service agent
repair the product.
Low battery voltage. Charge the
battery.
Replace or install the HEPA fil-
ter.
Let an approved service agent
repair the product.
Make sure that correct power
supply is used.
Make sure that the ambient
temperature is in specified
range when you use the prod-
uct.
Let an approved service agent
repair the product.
Connect the dust extraction
hose.
Clean the dust extraction hose.
Install a Longopac cassette.
Attach a cable tie.
Make sure that correct power
supply is used.
Replace the dust extraction
hose.
Remove dust particles from the
prefilter. Clean or replace it if it
is necessary.
Replace the HEPA filter. Refer
To replace the HEPA filter on
to
page 21 .
Close the top cover fully.
Replace the seals.
1618 - 004 - 24.01.2022