Transportation, Storage And Disposal - Husqvarna DE 110S Bedienungsanweisung

Error
Error
code
High supply volt-
4
age.
Main Pressure
5
Sensor Error.
PCBA tempera-
6
ture too high.
7 Fan malfunction.
One wire com-
9 munication not
detected.
To move the product short distances
Make sure that the intake valve is closed. Make sure
that the dust caps are on the hoses.
1. Put the product down on the ground. (Fig. 31)
2. Lift the product manually. (Fig. 32)
3. If 2 persons lift the product, make sure to use the 2
lifting points. (Fig. 33)
To move the product long distances
Make sure to use a closed vehicle during transportation
of the product.
Make sure that the intake valve is closed. Make sure
that the dust caps are on the hoses.
1. Make sure that the Longopac is installed on the
product.
2. Make sure that the Longopac bag is empty.
3. Attach the power cord, the dust extraction hose and
the handle pipe tightly to the product. (Fig. 34)
4. Lock the transport wheels. (Fig. 10)
5. Lift the product, refer to
21 .
1587 - 007 - 24.01.2022
Description
Product shuts down/does not
start.
+ Warning diode light on HMI.
Prefilter light flashes red.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Product shuts down/ does not
start.
+ Warning diode light on HMI.
Product shuts down/ does not
start.
+ Warning diode light on HMI.

Transportation, storage and disposal

To lift the product on page
Probable cause(s)
Too high voltage in grid/power
supply.
Wrong battery used.
Vacuum hose is disconnected
or blocked.
Control unit is damaged.
Too high ambient temperature.
Fan is damaged or disconnec-
ted.
Control unit is damaged.
Cable disconnected or dam-
aged.
6. Attach the product safely to the transportation
vehicle to prevent damage and accidents. Use the
tie-down points. (Fig. 35)
To lift the product
WARNING:
equipment and the lifting straps have the
correct specification to lift the product safely.
The type plate on the product shows the
product weight, refer to
9 .
WARNING:
about how to lift heavy equipment.
WARNING:
dust in the tank or in the bag. Do not lift
the product with added weight in or on the
product.
1. Do the filter purge procedure before you lift the
To remove dust particles from the
product. Refer to
prefilter during operation on page 15 .
Action(s)
Make sure correct
grid/power supply is
used.
Use correct battery.
Speak to an ap-
proved service agent.
Do not use the prod-
uct outside specified
temperature range.
Speak to an ap-
proved service agent.
Speak to an ap-
proved service agent.
Make sure that the lifting
Type plate on page
Get aid if you are not sure
Do not lift the product with
21