To Clean The Product - Husqvarna DE 110S Bedienungsanweisung

Maintenance
Look for signs of wear or damage of the
dust release rubber cone.
Do a check of the power plug and the
power cord.
Look for signs of wear, damage or loose
connections of the controls before the
unit is connected.
Do a check of the hose and the hose
connectors.
Look for signs of wear or damage of the
plastic parts.
Do a check of the lifting eyes.
Make sure that the Longopac is correct
and that it is correctly attached. Refer to
To install a new Longopac bag cassette
on page 15 .
Do a check of the filter purge function.
Do a check of the wheels. Look for
damage and bad connections.
Do a check of the filter seals.
Do the filter purge procedure. If the
suction continues to be not sufficient,
clean the prefilter with water. Refer to
To clean the prefilter with water on page
18 .
Replace the cleaned prefilter if the suc-
tion continues to be not sufficient. Refer
To replace the prefilter on page 18 .
to
Replace the HEPA filter.
Replace the dust release rubber cone.
Replace the filter cleaning rubber parts.
To do a check of the functions of the
control panel
1. Start the product. Refer to
110/DE 120 on page 15 .
2. Push and hold the On/Off button. Refer to
of the control panel on page 14
3. Make sure that the product stops and that the green
LED goes off.

To clean the product

Operation can cause contamination on all parts of the
product and all used equipment. Thus it is necessary to
1587 - 007 - 24.01.2022
Before
each use
X
X
X
X
X
X
To start and stop DE
Functions
Daily Weekly suction is
X
X
X
X
clean all parts of the product and all used equipment
fully and carefully.
WARNING:
from the power supply.
WARNING:
it is moved from the work area. Remaining
dust on the product can go into the air and
cause a health risk.
• Use personal protective equipment. Refer to
Personal protective equipment on page 12 .
When Each 6
months or months or
low 600 h
X
X
X X
Disconnect the product
Clean the product before
Each 12
2000 h
X
X
X
17