Herunterladen Inhalt Inhalt Diese Seite drucken

Product Elements; Intended Use; Protection Of The Unit; Inserting/Replacing The Batteries - Bosch wallSCANNER D-TECT 100 concrete PROFESSIONAL Bedienungsanleitung

Ortungsgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

dtectc_bu_1609929H74_t.fm Seite 2 Montag, 21. März 2005 1:49 13

Product Elements

Please open the foldout page with the illustration of the unit and leave
it open while you read these operating instructions.
The numbering of the product elements refers to the illustration of the
unit on the graphic page.
1 Screw
2 Wheel
3 Display
4 Display lighting button
5 "on/off" button
6 "start" measurement button
7 Handle
8 "mode" button
9 Aligning aid
10 Sensor area
11 Battery compartment cover
12 Battery compartment latch
13 Serial number
14 Protective bag

Intended Use

The unit is intended for searching for objects such as, for example, re-
inforcing metal, plastic pipes, lines and cables in concrete as well as the
indication of the depth of the objects found.

Protection of the Unit

Protect the unit from moisture and direct sunrays.
s
In order not to influence the measured results, no stickers or name-
s
plates may be attached to the sensor area 10 on the back of the
unit, especially nameplates of metal.
If the unit is not used for a long period, the batteries must be re-
s
moved (danger of corrosion).
Transport and store the unit in the protective bag 14.
s

Inserting/Replacing the Batteries

Use alkali-manganese or rechargeable batteries exclusively.
To open the battery compartment cover 11, press the latch 12 in direc-
tion of the arrow (a) and lift up. Remove the battery compartment cover
(b). Insert the batteries provided. (See the illustration on the fold-out
page.)
When inserting the batteries, pay attention to the correct polarisation.
When the small battery symbol
pears in the upper left of the display, the
unit can still be operated for approx.
30 min when using alkali-manganese bat-
teries (shorter period for rechargeable
batteries).
If the indication shown here appears in the
display, the batteries must be replaced.
Measurements are no longer possible.
Always replace the complete set of bat-
tery. Use only batteries of a single manu-
facturer with the same capacity.
English–2
1 609 929 H74 • (05.03) T
ap-

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis