Troubleshooting - Meec tools 013514 Bedienungsanleitung

• If the condensate is not drained the tank
can corrode, leading to reduced capacity
and putting safety at risk.
IMPORTANT:
Dispose of condensate in accordance with
local regulations for contaminants.

TROUBLESHOOTING

The compressor does not start, or stops
when in use.
• Check that the plug is plugged in.
• Check that the power point is supplied
with voltage.
• Check that the ambient temperature is
not too low (the compressor is not
intended to be used in an ambient
temperature less than 5°C).
• Check that the motor is not overheated so
that the overheat protection has tripped.
If this is the case, allow the compressor
motor to cool and then start again.
The compressor starts but does not build up
pressure.
• Check that the drain valve is closed.
• Check that all the connected hoses and
pneumatic tool are tight.
EN
25