Maintenance - Meec tools 013514 Bedienungsanleitung

EN
or if for any other reason the pressure in the
air tank gets too high, the pressure in the tank
is relieved by a safety valve. The compressor is
oil-free and is only intended for intermittent
use. This means that it can only be used for
purposes that consume a low volume of air,
such as nailers and other small pneumatic
tools, filling footballs and other sports
equipment, toys, airbrush sprays and other
spray tools.
NOTE:
The compressor is not intended to be used to
pump large objects such as pools or inflatable
mattresses that require a run time of more
than 120 seconds.
1. Power cord
2. Safety valve
3. Pressure gauge
4. Power switch
5. Handle
6. Cord retainer (on each side)
7. Motor casing
8. Air outlet
9. Pressure control knob
10. Air tank
11. Drain valve
FIG. 1
USE
1. Check that the power switch (4) is in the
OFF position.
2. Plug the plug into an earthed power point.
3. Connect the pneumatic tool to be used to
the air outlet (8).
4. Switch on the power switch (ON).
5. Set the required working pressure with the
pressure control knob (9).
24
After use
Never disconnect any pneumatic tools before first
relieving the pressure in the air tank.
1. Switch off the product and pull out the plug.
2. Relieve the pressure in the air tank and then
allowing the product to cool.
3. Disconnect the pneumatic tool and wind
the cord on the cord retainers (6).

MAINTENANCE

Clean the product with a damp cloth. Use a
mild detergent, not solvent or caustic solution.
WARNING!
The safety valve should not be tampered with
or blocked under any circumstances.
• Check the air tank for external or internal
corrosion at least once a week. The wall
thickness of the tank must under no
circumstances by less than 2 mm.
• Drain condensation from the air tank at
regular intervals by opening the drain
valve. Relieve the pressure in the air tank
and allowing the product to cool, before
opening the drain valve.
• If the product is not going to be used for
some time pull out the plug, relieve the
pressure in the air tank and empty the
tank of condensation by opening the
drain valve (11).
• Do not use solvents, flammable or toxic
liquids to clean the machine and its
components. Only clean with a soft, damp
cloth. Check that the plug has been
unplugged from the power point.
• Empty the condensate formed in the tank
after about 2 hours of use. Activate the
connected accessory to empty the tank.
Switch off the compressor. Undo the
emptying valve 5 under the compressor
two turns. The compressor should be in an
upright position. Empty out the water and
screw tight the valve.