Checking The Battery Charge Status; Maintenance And Care; Help In Case Of Malfunction - AL-KO solo MT 42.2 Bedienungsanleitung

GB
2. Press and hold locking button (06/2) with
your thumb.
3. Press and hold throttle lever (06/1).
4. Release unlocking button (06/2). It is not nec-
essary to keep the unlocking button pressed
once the Multitool has started. The unlocking
button is intended to prevent inadvertent
starting of the Multitool.
5. Push switch (06/3) to the desired mode:
■
POWER (high speed): Push switch for-
wards (07/a).
■
ECO (low speed): Push switch back-
wards (07/b).
Switching off the appliance
1. Release throttle lever (06/1).
6.2

Checking the battery charge status

The charge status indicator is located on the bat-
tery.
NOTE For detailed information, see the sep-
arate operating instructions for the rechargeable
battery and the charger:
■
Operating manual 441630: Li ion recharge-
able battery B150 Li (B05-3640G), B200 Li
(B05-3650G)
■
Operating manual 441633: Charger C130 Li
(C05-4230)
Malfunction
Motor of the attachment
does not start.
Motor of the attachment
runs erratically.
Battery operating time
drops significantly.
Battery cannot be
charged.
24
Cause
Battery is flat.
Battery missing or not insert-
ed correctly.
Power supply is interrupted.
Throttle lever is defective.
The service life of the battery
has expired.
Battery contacts are soiled.
Battery or charger is defec-
tive.
Battery is too hot.

7 MAINTENANCE AND CARE

WARNING! Danger of lacerations. Danger
of cutting injuries when reaching into sharp-
edged, moving appliance parts and into cutting
tools.
■
Before maintenance, care and cleaning work,
always switch off the appliance. Remove the
rechargeable battery.
■
Always wear protective gloves during mainte-
nance, care and cleaning work.
■
Do not get the appliance wet or expose it to
moisture.
■
Clean plastic parts with a cloth and do not
use any cleaning agents or solvents.
■
Check the electrical contacts for corrosion,
clean with a fine wire brush if necessary and
then spray with a contact spray.

8 HELP IN CASE OF MALFUNCTION

NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
Charge the battery.
Install the battery correctly.
1. Remove the battery.
2. Clean the plug contacts of the basic
appliance, shaft extension and at-
tachment.
3. Install the battery again.
Contact one of the manufacturer's ser-
vice centres.
Replace the battery. Use only OEM ac-
cessories.
Contact one of the manufacturer's ser-
vice centres.
Contact one of the manufacturer's ser-
vice centres.
Allow the battery to cool down.
Maintenance and care
MT 42.2