Beko BDSA250K3SN Gebrauchsanweisung Seite 68

Installation
Use the test strip supplied with the product according to the steps given below to determine
hardness level of your supply water.
Remove the test Turn on the tap and
strip from the let the water run for
packet. about a minute.
After determining hardness level of the supply water:
1. Turn on the machine, press Time Delay and P+/P keys simultaneously. After the countdown
(3,2,1) is displayed keep the keys pressed for a while.
2. Press P+/P key to activate the (r..) position.
3. Using Time Delay key, adjust water hardness level according to the hardness of the supply
water. See "Water hardness level adjustment table" for correct setting.
4. Press On / Off key to save the setting.
Water hardness level adjustment table
Hardness English Water German Water
Level Hardness °dE Hardness °dH
0th Level
0-5
1st Level
6-9
2nd Level
10-15
3rd Level
16-19
4th Level
20-24
5th Level
25-62
If the hardness level of the supply water is above 90 °dF or if you are using well water, then it
is recommended to use water purification devices and special filters.
If the hardness level of the supply water is below 13°dF, there is no need to use salt in your
dishwasher. If this is the case, "No Salt Warning Indicator" (if any) illuminates continuously on
the panel of your machine.
If the water hardness level adjustment is set to level 1, the "No salt warning indicator" will
illuminate continuously although it is not necessary to use salt. If you use salt under this
condition, salt will not be consumed and the Salt indicator will not illuminate.
14 /45 EN
Hold the test strip in Remove the test
the water for about strip from the water
a second. and shake it.
French Water
Water Hardness Level Indicator
Hardness °dF
0-4 0-8
Press the Time Delay key to switch the water hardness level
to position 1. (r1)
5-7 9-13
Press the Time Delay key to switch the water hardness level
8-12 14-22
to position 2. (r2)
Press the Time Delay key to switch the water hardness level
13-15 23-27
to position 3. (r3)
Press the Time Delay key to switch the water hardness level
16-19 28-34
to position 4. (r4)
Press the Time Delay key to switch the water hardness level
20-50 35-90
to position 5. (r5)
Wait for 1 minute. The test strip shows
you the hardness
level.
Dishwasher / User's Manual