Beko BDSA250K3SN Gebrauchsanweisung Seite 88

Operating the product
You can select and start a
C
new programme following the
cancellation of Time Delay
function.
C
Time Delay function cannot be
set after the programme starts.
Start ng the programme
Close the door of your machine to start it
after selecting the programme and auxiliary
functions.
C Your machine performs water
softening depending on the
hardness level of the supply
water. Washing time can
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the dishes.
C Pay attention not to open the
door of the machine when it is
running. There may be a rush of
vapour when you open the door
of your machine; be careful.
C The machine will remain silent
in pause mode for some time
in order to remove the water
from the machine and on the
dishes completely and to have
the water softener cleaned, and
then it will resume running in
drying mode.
Cancell ng the programme
Open the door of the product Press and
hold the Programme Selection / Programme
Cancel keys for 3 seconds. After the 3 -
34 /45 EN
2 - 1 countdown, 0:01 is displayed, close
the door of the product and wait for the
draining process complete. Draining is
completed in 2 minutes and the machine
gives an audible warning when it is
completed.
C There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt nd cator ( )
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
C Adjusting the water hardness
level is explained in Water
Softening System section.
R nse A d nd cator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
Adjust ng the amount of
r nse a d
1. After turning on the machine,
press Time Delay and P+ keys
simultaneously. After the countdown
(3, 2, 1) is displayed keep the keys
pressed for a while.
2. Press P+ to move to position (P) on the
display.
Dishwasher / User's Manual