App Installation & Setup; Operation Introduction - Topdon BTMOBILE PROS Bedienungsanleitung

APP Installation & Setup
Installation:
Please scan the QR code or visit our offical website:
https://www.topdon.com/products/btmobile-pros to
download and install the APP.
NOTE: Compatible with Android 4.4 smart devices,
or newer.
Set up
For the first time, you
can choose to register
with email or skip
login. But we strongly
recommend the
registration for latest
product news and timely
technical assistance.
5

Operation Introduction

Before Test:
1.Before you test a battery in a vehicle, turn off the ignition, all accessories and loads. Close all of the
vehicle's doors and trunk lid.
2.Make sure the battery terminals are clean. Use a wire brush to clean them, if necessary.
NOTE: This tester works best if the battery connectors have been removed and the battery posts have
been cleaned. Any corrosion between the tester clamps and the battery connectors, or between the
battery connectors and the battery posts, will degrade the tester's efficiency.
3.Connect the RED (+) Positive Battery Clamp to the (+) positive battery terminal, and connect the BLACK
(-) Negative Battery Clamp to the (-) negative battery terminal. Ensure that the clamps are securely
attached to the correct terminals.
4.Open the Bluetooth on mobile device or tablet.
5.Test Introduction
• BATTERY TEST: Display SOH (State of Health), SOC (State of Charge), Voltage, Test Value, Internal
Resistance, and the readable analysis results on App;
• CRANKING TEST: Analyze the actual cranking voltage and the cranking time to help you quickly figure
out the whole state of the starting system;
• CHARGING TEST: Test different parts of charging system, including generator, rectifier, rectifier diode,
and so on for a reliable charging volt value.
6