| TROUBLESHOOTING
PROBLEM
The remote does not work.
The IS-1000 is not listed on
the GN Control app.
CAUSE
|
The GN remote can be
used to control more than
one unit.
To control each unit the
correct mode must be
selected on the remote.
|
The IS-1000 is not
connected to the network.
21
SOLUTION
|
Press the "AMP" button
on the remote.
|
Make sure the IS-1000 is
connected to the WLAN
or LAN either with the
Ethernet cable or the
Wi-Fi.
|
Make sure the RF antenna
is correctly installed.
It may be impossible to
use the IS-1000 with the
Wi-Fi if the RF antenna is
not installed.
|
When using Wi-Fi,
make sure the IS-1000 is
connected to the correct
WLAN. Don't forget to
put in the password to
complete the connection
if required by your
network setup.