Programmes - IKEA RENLIG Handbuch

ENGLISH
To open the door during the first minutes of
the cycle or when the delay start operates:
1. Press the button
appliance.
2. Wait some minutes until the door
unlocks.
3. You can open the door.
4. Close the door and touch the button
again. The programme (or the delay)
continues.
At the end of the programme
• The appliance stops automatically.
• The indicator of the button
After a couple of minutes the phase
indicator illuminates and stays on.
• Turn the programme knob to position
to deactivate the appliance.
• You can open the door.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Close the water tap.
• Keep the door and the detergent drawer
ajar, to prevent the mildew and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The indicator
to drain the water.

Programmes

Programme Chart
Please always refer to the care label symbol of your garment and select the
washing programme based on what it says.
to pause the
goes off.
stays on to remind you
• The indicator of the button
door is locked.
• You must drain the water to open the
door.
Draining the water:
1. Set a draining or a spinning
programme.
2. Press the button
The appliance drains the water and spins.
3. When the programme is completed:
• The indicator of the button
off and after a couple of minutes the
phase indicator
• You can open the door.
4. Turn the programme knob to the
position to deactivate the appliance.
Stand by
Some minutes after the end of the washing
programme, if you do not deactivate the
appliance, the energy saving status
activates. The energy saving status
decreases the energy consumption when
the appliance is on the standby:
• All indicators go off.
• The indicator of the button
slowly.
Press one of the buttons to deactivate the
energy saving status.
13
is off. The
.
goes
illuminates.
flashes