Single Dialling; Block Dialling - Eaton ExResistTel IP2 Kurz- Betriebsanleitung

2.3.3.1

Single Dialling

For single dialling take the following steps:
Torsten
0211654321
Please dial
06.01.10
Figure 16: Direct Dialling
1. Respectively to the wanted calling mode:
Pick up the handset (handset mode).
Press the loudspeaker key
Press the headset key (Key
loudspeaker key ) (headset mode).
2. Enter the phone number. In this case the VoIP telephone dials the number while it is
being entered.
3. To finish a call respectively to the active operating mode:
• Put the handset back on its rest (handset mode).
• Press the key
• Press the loudspeaker key
• Press the headset key (Key
loudspeaker key
2.3.3.2

Block Dialling

For block dialling do the following steps:
1. Let the handset on its rest and don't activate the hands free or headset mode.
2. Enter the phone number completely.
3. When entering the telephone number, you may edit already entered digits. Use the
and keys to move the cursor, and the key
cursor.
4. Respectively to the wanted calling mode, you can setup the call as follows. In this
matter, it will be dialled after one of the following activities.
a. Lift off the handset (handset mode).
22
72
14:40 0:00
(hands free mode).
long (longer than a second) and then the
(All modes).
(hands free mode).
long (longer than a second) and then the
) (headset mode).
to delete the digit to the left of the