Mounting And Installing - Eaton ExResistTel IP2 Kurz- Betriebsanleitung

1.5 Mounting and Installing

The device must be installed on a plane surface only, in vertical operating position.
Loosen the cover screws (2) (see Figure 6 to Figure 8) and detach the upper part of the
telephone (1). If the optional accessory headset or a second earpiece is being employed,
attach the bracket (10) using two screws (11) to the rear panel of the lower part of the
telephone. (With the accessories named before, the bracket and screws are in the scope
of delivery. With all accessories a cable gland is delivered.) Put four screws, having a
head diameter of 10 to 13 mm into the holes (20) and attach the lower part of the
telephone (3) to the wall or to a holder.
The telephone network cable should be passed through the cable entry (4) and
connected to terminals in accordance with the connection diagram. The attached
operating instructions for cable glands have to be considered.
Prior to assembly, check cover seal for tightness. Using the plug connector (7), plug the
ribbon cable onto the pin contact strip (8) in the upper part of the housing. Attach the
upper part of the telephone and fasten it to the lower part of the telephone with the four
cover screws (2). Upon disassembly of optional accessories, suited sealing plugs must be
used to close the resulting openings.
In this telephone connected cords may have hazardous voltages.
To ensure that no water gets into the enclosure it is essential that no gaskets are
damaged during installation. The ingress of water can cause accessible parts of the
telephone to become live.
Installation and connection must be carried out by competent personnel familiar with
electrical and network installations.
201
Figure 5: Drilling Diagram Wall Mounting
The diameter of the drilled hole is dependent on the screw employed (screw diameter
max. 8 mm) and the type of supporting base material (steel, wood, concrete,
plasterboard etc.) and must be chosen accordingly.
9