Lan-Connections; Default Version One Lan Connection With A Cable Gland; Cable Glands - Eaton ExResistTel IP2 Kurz- Betriebsanleitung

1.5.1 LAN-Connections

1.5.1.1

Default Version one LAN Connection with a Cable Gland

The telephone has in the default version one internal LAN-connection with a Cable Gland.
For the connection a LAN cable must be pulled through the Cable Gland. Inside the
phone the female LAN connection from AMP NETCONNECT (TE Connectivity) has to be
pressed on the cable (Refer to chapter 1.4 beginning on page 8). A female LAN cable
connector belongs to the as-delivered condition. With the inside the phone existing little
LAN connection cable, the LAN can be connected with the phone.
The LAN delivery can be available with PoE (Power over Ethernet). Alternatively the
phone can be supplied with power external.
All not used cable feed through have to be closed with sealing plugs.
Caution
You can use PoE (Power over Ethernet) or an external connection to supply the

ResistTel IP2 / IP152 with power.
Don't use both at the same time, to prevent damage to the equipment.
1.5.1.2 Version
Connections with Cable Glands
The telephone has in this version two internal LAN-connections with a Cable Gland. For
the connection the LAN cable must be pulled through the Cable Gland. Inside the phone
the female LAN connection from AMP NETCONNECT (TE Connectivity) has to be pressed
on the cable (Refer to chapter 1.4 beginning on page 8). A female LAN cable connector
belongs to the as-delivered condition. With the inside the phone existing little LAN
connection cable, the LAN can be connected with the phone.
The LAN1 delivery can be available with PoE (Power over Ethernet). Alternatively the
phone can be supplied with power external.
The LAN2 delivery doesn't support PoE. Also it can't be used to connect a phone directly,
which should be powered with PoE.
All not used cable feed through have to be closed with sealing plugs.
with Switch LAN Module with two LAN
13
