External Power Supply Connection; Relay Connection - Eaton ExResistTel IP2 Kurz- Betriebsanleitung

1.5.2 External Power Supply Connection

An external power supply can be adapted to the terminals 5 (+) and 6 (-). The voltage
has to be:
 Without using the optional voltaic separated inputs: 15 V – 57 V DC, 12.95 W
 With using the optional voltaic separated inputs: 21,5 V – 57 V DC, 12.95 W
If the external power connection will be used, you must not use PoE at the LAN
connection.

1.5.3 Relay Connection

The phone can be build up with a relay module with two relays with a single changeover
switch optional.
The maximal breaking capacity of a relay is depending on the voltage:
240 V, 6 A, AC
•
• 24 V, 6 A, DC
32 V, 5 A, DC
•
48 V, 1 A, DC
•
Figure 11: Connection Diagram Relay Module
Caution

Do not open the housing of the telephone while the relay contacts are energized.
14
K1
Relais 1 Relais 2
1 2 3 1 2 3
