Schedule Mode - Grundig VCR 3130 Bedienungsanleitung

3 Operation

Schedule mode

3.3.7
When you successfully set the scheduled cleaning timing, the appliance will start cleaning automatically
at the scheduled time.
3.4 Scheduling through remote controller
To enter the scheduling mode, push and hold the "CLK" button on the remote controller (15). Blinking
digits will be displayed on the screen, you may use the up and down buttons to change the blinking
digits. After entering a number, proceed to the next digit to be set, using left and right buttons. After the
time is set, the day information in the top line can be changed each time the right button is pressed.
Finally, push the "CLK" button on the remote controller, the screen will stop blinking which means the
time is set.
3.4.1 How can one schedule the robot through remote controller? Setting with
remote controller
A. Setting the schedule time
a. Make sure the robot is in standby or charging state, then push and hold the "PLAN" button on the
remote controller, the remote controller will switch to scheduling mode.
b. Blinking digits will be displayed on the screen, you may use the left and right buttons to proceed to
the next digit to be set.
c. Once set, push the "ON/OFF" button on the remote controller, you will hear a short beep sound if the
scheduling was successful.
d. After hearing the short beep sound, you may return to the home screen by pushing and holding the
"PLAN" button.
When setting the scheduling, the number on the remote controller (15) is the delay time.
For instance, let's assume it is 8 AM right now and the setting on the remote is 01:00.
C
When the setting is successful, the appliance will start operating in 1 hour. That means it will
start at 9 AM. However, it will only operate at 9 AM in that day. If the main switch is turned
off before reaching the scheduled time, the scheduling will be cancelled. And each time a
scheduled hour is entered, it will only be available for one hour.
A. Cancelling a programme time
When the remote controller (15) is in the scheduling mode, push and hold the "ON/OFF" button again,
00:00 will be displayed on the remote controller screen. Then, push on the "ON/OFF" button to cancel a
programme time. If successful, the appliance will make a beep sound twice. After hearing the short beep
sound, you may return to the home screen by pushing and holding the "PLAN" button.
Robot Vacuum / User's Manual
39 / EN