Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All manuals and user guides at all-guides.com
Manual
3.6. Installation under Windows XP
3.6.1. Installing in an Existing System
Once the RAID controller is properly installed and you restart your system,
Windows XP will find a new device while booting up, a so-called "PCI-RAID
Controller". Insert the enclosed driver CD now and click on "Continue". Software
for your DC-154 RAID will now be automatically installed. Complete installation
by clicking on "Finish".
You can verify the installation by opening the device manager under "SCSI
Controller", where the entry "Silicon Image SiI 3114 SATARaid Controller" should
be found. If this is not the case, open the "RAID Troubleshooting" section of this
manual.
3.6.2. New Windows XP Installation
The new Windows XP Installation can be compared to the new Windows
2000 installation; please read paragraph 3.5.2.
4. The Graphical Silicon Image User Interface
To install the graphical silicon image user interface, insert the enclosed driver CD.
In the instantly appearing window select under „Support/Downloads" the link "SATA /
IDE driver", then click on "GUI für Windows: nicht für RAID 5" and "Open". Software
installation is now initiated. Please follow the instructions on the screen.
If the JAVA environment has not yet been fully implemented on your computer,
internet access is required for installation.
After installation, a symbol to start the silicon image user interface (simply called
"SATARaid GUI" in the following) will appear on the taskbar next to the clock. Double-
clicking this symbol activates the SATARaid GUI. In the window now opening you can
make adjustments or configure the SATARaid GUI. Detailed instructions for this
software are found on our homepage www.dawicontrol.com.
- 35 -
Werbung
