Securing Your Child In The Child Restraint - Nuna myti Bedienungsanleitung

Use top tether for installation if vehicle is
equipped with a tether anchorage fitting and
vehicle requirements are met (see vehicle owner's
manual).
8
- Make sure that tether hook are securely attached
to the anchorage fitting. (19) The colors of the
indicators on tether strap adjuster should be
completely green.
9
- Make sure that both ISOFIX connectors are
securely attached to their ISOFIX anchor points.
The colors of the indicators on both ISOFIX
connectors should be completely green. (20)
Removing the child restraint
1
- Press the release button (21) to loosen the
webbing and then detach the hook to remove the
top tether. (22)
2
- To remove base from the vehicle press the ISOFIX
release button and pull the base back from the
seat. (23)
3
- Then press and pull back on the ISOFIX
connector on both sides. (24)
4
- For transporting, press ISOFIX release button
and move back ISOFIX connector so it is folded
completely. (25)
15
MYTI Instructions

Securing your Child in the Child restraint

1
- Press the webbing adjustment button, while
pulling out the shoulder harnesses to the proper
length. (26)
2
- Press the red button to disengage the buckle.
(27) -1
3
- Fix the buckles on the both sides of seat to make
placing the baby more convenient. (27) -2
4
- Place the child into the child restraint and pass
both arms through the harnesses. (28)
5
- Engage the buckle. (29)
6
- To ensure the head support is at the correct
height, the bottom of the headrest MUST be
even with the top of child's shoulders as shown
in (30).
The maximum distance between the shoulder of
baby and shoulder hole is 4 cm (31).
7
- Pull down the adjustment webbing and adjust it
to the proper length so that your child is snugly
secured. (32)
8
- Be able to fix the webbing under the soft goods.
(33)
Make sure the space between the child and the
shoulder harness is about the thickness of one
hand.
9
- Move the baby out shown as (34) (35).
16
MYTI Instructions