Securing Child - Nuna pipa urbn Bedienungsanleitung

Head Support Height Adjustment
Shoulder harness straps must be nearest to your childs shoulders (15).
If the shoulder harness straps are not at proper height, the child might be
ejected from the enhanced child restraint if there is a crash.
Pull the head support up or down to adjust the position. (16)

Securing Child

Use Infant Insert
We recommend using the infant
insert while the baby is under 60
cm or until they outgrow the infant
insert. The infant insert increases the
protection for children.
After the child is placed into the seat, check whether the shoulder harness straps
are at proper height.
1
- Press the harness adjustment button while pulling the shoulder harness to
the desired length. (17)
2
- Unlock the buckle of the harnesses by pressing the red button. (18)
3
- Place the child into the infant carrier and lock the buckle. (20) Engage the
buckle. Please refer to (19).
4
- Pull down the adjustment webbing and adjust it to the proper length to make
sure your child is properly secured. (21)
Make sure the the shoulder harness straps are snugly tightened. Any belt
slack reduced the safety performance of the child restraint system.
Installation using ISOFIX system
1
- Attach the ISOFIX guides to the vehicle's ISOFIX anchor bars. (22) The
ISOFIX guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
2
- Rotate ISOFIX Connectors down (23). This also lowers the recline bar, which
helps position the child restraint at the correct angle for installation (24).
9
PIPA urbn instructions
Remove the infant insert when
the infant's shoulders no longer fit
comfortably.
3
- Place the infant carrier onto the vehicle seat where you would like to install.
(25)
4
- Line up the ISOFIX connectors with the ISOFIX guides, and then click both
ISOFIX connectors into the ISOFIX anchor bars. (26)
Make sure that both ISOFIX connectors are securely attached to their
ISOFIX anchor bars. There should be two audible clicks and the colors of
the indicators on the both ISOFIX connectors should be completely green.
(26)-1
Check to make sure the child restraint is securely installed by pulling on
both ISOFIX connectors.
5
- Make sure the level line on the restraint label is as level as possible with the
ground. (27)
6
- To remove the infant carrier, squeeze the ISOFIX release button on the back
of infant carrier and pull the infant carrier away from the ISOFIX anchor
bars. (28)
7
- Rotate ISOFIX Connectors up to storage position, and click them into place.
Remove child restraint from the vehicle. (29)
Installation using 3-point-belt
1
- Place the infant carrier onto the vehicle seat where you would like to install.
(30)
2
- Pull the vehicle safety belt out and lock it into the vehicle buckle. (31)-1
The infant carrier cannot be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the infant carrier module securely. (31)-2
Route the vehicle lap belt under both side guides. (31)-3
Route the shoulder belt around the back of the infant carrier passing
through the rear belt guide. (31)-4
3
- Tighten vehicle belt while pushing infant carrier firmly into vehicle seat to
fasten the infant carrier module tightly and securely. (32)
4
- Level line on the restraint label must be level with the ground when the
infant carrier is installed. (33)
Make sure the vehicle belt is as tight as possible around the infant carrier
and the belt is not loose or twisted.
After installing the infant carrier, always check that the vehicle belts are
routed correctly and securely fastened into the vehicle buckle. (34)
10
PIPA urbn instructions