Makita DF010D Bedienungsanleitung Seite 6

Guideline for clutch auto-stop
Work range of clutch auto-stop
High speed
Clutch auto-stop works
Clutch auto-stop
does not work
When driving machine
screws
008943
Lighting up the front lamp
Fig.6
Fig.7
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the light, slide the lamp switch to the A
position. To turn off the light, slide the lamp switch to B
position.
Even if you leave the lamp on, the light will automatically
turn off after 5 minutes.
Checking the remaining battery capacity,
auto-stop
The lamp signals by flickering when the battery power is
almost used up during use,.
At this time, recharge the battery or replace the battery
with a fully charged one.
All manuals and user guides at all-guides.com
Low speed
Increments
1 - 3
4 - 8
9 - 18
19 - 21
Increments on adjusting
ring for fastening torque
1
5
9
13
17
21
Guideline for machine screw diameter
ASSEMBLY
CAUTION:
Always be sure that the lock button is in the locked
•
position B and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit or socket bit
Fig.8
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
6
Fastening torque
Approx. 0.3 N m
(Approx. 3 Kgf-cm)
Approx. 0.82 N m
(Approx. 8.4 Kgf-cm)
Approx. 1.35 N m
(Approx. 13.8 Kgf-cm)
Approx. 1.88 N m
(Approx. 19.2 Kgf-cm)
Approx. 2.41N m
(Approx. 24.6 Kgf-cm)
Approx. 2.9 N m
(Approx. 30 Kgf-cm)
Low speed
Approx. 5 N m
(Approx. 49 Kgf-cm)
High speed
Approx. 1.5 N m
(Approx. 14.7 Kgf-cm)
2.5 mm
3 mm
4 mm
5 mm