Troubleshooting Guide - Kenwood JEP01 Bedienungsanleitungen

troubleshooting guide

Problem
The juicer will not operate
Motor appears to slow or
stop during use
Pulp too wet and low juice
extraction
Juice leaking between lid
and pulp collector
Cause and Solution
Juicer not plugged in.
G
Juicer not assembled correctly. Check that:
G
the lid is latched correctly.
Refer to the recommended usage chart to
G
check that you are using the correct speed.
If processing hard or fibrous foods, check
G
that the pulp collector is not full and that
there is not a build up of pulp on or around
the filter.
Switch off and unplug, then empty the
pulp collector and clean the filter/holder.
Use a slower juicing action and process
G
small quantities at a time.
Clean filter if processing very fibrous foods.
G
Refer to the recommended usage chart to
G
check that you are using the correct speed.
Wrong speed used. Refer to the
G
recommended usage chart.
Food pushed down feed tube too fast. Use
G
a slower action.
Check pulp collector is latched correctly.
G
7