Kenwood JEP01 Bedienungsanleitungen Seite 3

Misuse of your appliance can result in injury.
G
Appliances can be used by persons with
G
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use of
the appliance in a safe way and if they
understand the hazards involved.
Only use the appliance for its intended
G
domestic use. Kenwood will not accept any
liability if the appliance is subject to improper
use, or failure to comply with these
instructions.
before plugging in
Make sure your electricity supply is
G
the same as the one shown on the
underside of your juicer.
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
before using for the first time
1 Remove all packaging.
2 Wash the parts: see 'care and
cleaning'.
key
pusher
hopper
feed tube
lid
filter
filter holder
juice outlet
lid with foam separator
juice jug
interlock
On/Off speed control
pulp collector
cord storage (at the back)
using your juicer
assembly and use
1 Slide the pulp collector
position and fit the filter holder
2 Fit the filter
3 Fit the lid
on the feed tube and slide the
interlock switch
Your juicer will not work if the
G
lid is unlocked.
DO NOT operate the juicer
G
without the pulp collector
fitted.
4 Place the hopper
5 Fit the Juice Jug with the lid fitted
under the outlet.
6 Use the recommended usage chart
as a guide for juicing different fruits
and vegetables.
7 Switch on
items down with the pusher
8 After adding the last piece of food;
allow the juicer to continue to run to
help clear the juice from the
filter/filter holder. The time will vary
depending on the fruit type and
thickness of the juice extracted.
9 Switch off and wait until the filter has
stopped and the final flow of juice
has reduced to a few slow drips.
3
into
inside the filter holder.
. Then push down firmly
to lock.
onto the lid.
and feed the food
.
.