Herunterladen Inhalt Inhalt Diese Seite drucken

Physical Transmitter Adjustments; Transmitter Mode Conversion; Programming Conversion; Mechanical Conversion - Spektrum DX8G2 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für DX8G2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 53
EN

PHYSICAL TRANSMITTER ADjUSTMENTS

TRANSMITTER MODE CONVERSION

You can change transmitter modes among Modes 1, 2, 3 and 4. This conversion requires both a programming and a mechanical change.

Programming Conversion

1. Access the System Settings menu from the Setup List
and select the desired Mode. If you are changing between
Modes 2/4 or 1/3, you can STOP after Step 1.
2. Exit the System Settings menu to save the selection.
3. Power off the transmitter and remove the transmitter battery pack.
After you change the transmitter Mode in the Setup List, you will
need to make mechanical changes to the transmitter gimbals.

Mechanical Conversion

CAUTION: Always power off the transmitter, disconnect and remove the battery before adjusting stick tension or friction straps.
Not doing so could result in property damage or injury.
Mechanical conversion is required to change between Modes 1 and 2 or between Modes 3 and 4. The mechanical conversion consists
of the following steps:
1. Change the Throttle Ratchet
2. Adjust the Elevator Centering Screw
3. Move the Throttle Limit Wedges

Changing the Throttle Ratchet

1. Disconnect and remove the battery from the transmitter and
set aside.
2. Remove the eight Phillips head screws that secure the rear
transmitter case half.
3. Put the transmitter face down on a piece of foam or a towel
and remove the rear case.
CAUTION: Use care to not pull or disconnect any of the
wires attached to the back transmitter half.
4. Locate the silver throttle friction straps on both gimbals. One
strap engages a serrated section on the gimbal for a ratcheted
throttle, while the other strap engages the smooth section on
the gimbal.
5. To change the throttle ratchet, loosen the throttle strap so it
does not touch the throttle gimbal. Tighten the opposite throttle
strap to engage the desired throttle ratchet.
If you only need to adjust the throttle friction, see the Adjust
Throttle Friction Straps section.
46
All manuals and user guides at all-guides.com
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis