Back Mixing; Range Test; Timer - Spektrum DX8G2 Bedienungsanleitung

FUNCTION LIST

Back Mixing

Back Mixing applies to all related servos in a multi servo Aileron/
Flapped wing or a multi servo split elevator. Creating a mix to RAL
(Right Aileron) or LAL (Left Aileron) will create different results and
enables you to use fewer mixes to achieve the desired response.
Example 1: Creating a mix AIL > RAL will move the ailerons in
opposite directions, while creating a mix AIL > LAL will move the
ailerons in the same direction.
Example 2: Create a mix ELE > REL will move the elevator halves
together, while mixing ELE > LEL will move the elevator halves in
the opposite direction (tailerons).

Range Test

The Range Test function reduces the power output. This allows for
a range test to confirm the RF link is operating correctly. Perform
a range check at the beginning of each flying session to confirm
system operation.
To Access the Range Test screen:
1. With the transmitter on and the main or telemetry screen
displayed, press the scroll wheel. The Function list displays.
2. Scroll to highlight Range Test, then press the scroll wheel to
access the Range Test function.
3. With the Range Test screen displayed, push and hold the
trainer button. The screen displays Reduced Power. In this
mode the RF output is reduced allowing for an operational
range test of your system.
4. If you let go of the trainer button, the transmitter will go back
to Full Power.
IMPORTANT: Telemetry alarms are disabled during the
Range Test.

Timer

The DX8 Timer function allows you to program a countdown timer
or stop watch (count up timer) to display on the main screen. An
alarm sounds when the programmed time is reached. You can
program the timer to start using the assigned switch position or
automatically when throttle is raised above a programmed position.
Two internal timers are available that show run time for a specific
model displays on the Main Screen. A total system timer is also
available.
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL
All manuals and user guides at all-guides.com
IMPORTANT: Be sure the right aileron is connected into the AIL
port on the receiver and the left Aileron is connected into the Aux1
port on the receiver.
Range Testing the Dx8
1. With the model restrained on the ground, stand 30 paces
(approx. 90 feet/28 meters) away from the model.
2. Face the model with the transmitter in your normal flying
position and place the transmitter into Range Test mode (see
above). Then push the trainer button; the power output will be
reduced.
3. Operate the controls. You should have total control of your
model with the transmitter in Range Test mode.
4. If control issues occur, contact the appropriate Horizon Product
Support office for assistance.
5. If performing a range test while a telemetry module is active,
the display will show flight log data.
EN
35