Installation Instructions - Klarstein FINESSA Bedienungsanleitung

EN
30

INSTALLATION INSTRUCTIONS

1. Select the type of installation: Exhaust function or Circulation function.
2. Mark the 6 hole positions on the wall (see installation diagram 1). The
maximum distance between the 2 top holes and the 2 middle holes should not
exceed 735 mm, depending on the ceiling height.
3. Drill the holes, and then insert the dowels into all the holes. The supplied
dowels are only suitable for solid walls. When fixing to other types of walls,
use suitable alternative fixings. Attach the suspension to the bottom holes
using 3 long screws (Installati- on Diagram 3). Next, screw 2 long screws into
the middle holes.
4. Use 2 long screws to attach the suspension to the top holes (installation
diagram 4).
5. Assemble the main unit and glass unit using 4 screws and washers. Tighten
the 2 screws with the hexagonal wrench. Then remove the aluminum filters
from the hood.
6. Place the hood on the 2 center screws and slide the hood down until it is fully
seated on the screws. Then fix the screws.
7. If you are using the recirculation function, install the 2 charcoal filters.
8. Reattach the aluminum filters to the hood.
9. Fix the exhaust hose (only required for exhaust function) with self-adhesive
aluminum tape and secure it to the hood with 2 short screws.
10. Extend the chimney to the correct length and secure it to the hood. Secure the
bracket to the chimney with two short screws.
11. Connect the top of the exhaust duct to your fume hood, following the
manufacturer's instructions. Then place the chimney on the hood.
12. Secure the chimney to the wall by screwing the middle bracket to the wall and
securing the extended chimney to the top wall bracket with short screws.