Kinderkraft MYWAY Bedienungsanleitung Seite 48

• Pull the lap belt towards the buckle to fasten it. Then, pull the shoulder belt to tighten the
other parts of the safety belt.
NOTE: Make sure the child safety seat is fixed well and stable. Check the belt and make sure
its route goes on correctly.
• Secure the child in the seat in accordance with sec. 4.4 and 4.5 (Fig. 5.3d).
5.4 Installing the front-facing child safety seat in weight groups 2 and 3 (15kg-36kg), using
the vehicle 3-point safety belts.
• Before installation, hide the seat harness (see section 6.1).
Remember: Store the cushion and pads in a safe place for the future use.
• Set the backrest of child seat in position "1".
• Place the child seat on the vehicle seat.
• Put the child in the child seat and pull the shoulder strap through the red guide under the
headrest (Fig. 5.4a).
• Guide the vehicle's seat belt through both lap belt guides (G). Fasten the vehicle seat belt
and make sure you hear a "click" (fig. 5.4b).
• Adjust the headrest to the child's height (see section 4.2).
• Tighten the vehicle seat belt by pulling the first section of the hip belt, and then the
shoulder belt section.
Make sure that the hip belt is stretched as low as possible over the child's hips, placed in the
guides and fixed in the buckle. The shoulder belt should be positioned between the shoulder
and the neck of the child.
5.5 Installing the front-facing child safety seat in weight groups 2 and 3 (15kg-36kg), using
the vehicle 3-point safety belts and additional ISOFIX attachments.
IMPORTANT The instruction manual of the vehicle manufacturer specifies the location of
ISOFIX fixing points and other necessary information regarding the installation of the seat in
the car. The user MUST read the instruction manual of the vehicle manufacturer.
• Before installation, hide the seat harness (see section 6.1).
Remember: Store the cushion and pads in a safe place for the future use.
• Set the backrest of child seat in position "1".
• Press on both sides of the ISOFIX release button (H) and pull out the ISOFIX attachments
(M) as far as possible (Fig. 5.5a).
• Attach ISOFIX guides to the seat connectors (Fig. 5.5b).
• Grab the seat with both hands and push the two fixing hooks in the back seat.
• When you hear the "click" of each ISOFIX attachments, push the seat to the back seat,
strongly and evenly pressing its both sides (Fig. 5.2c)
NOTE! The locking attachments are secure only when both button markers are completely
green.
• Grab the child seat and make sure it is securely fastened without play. If it moves and ISOFIX
attachments slip out, repeat the previous steps.
• Put the child in the child seat and pull the shoulder strap through the red guide under the
headrest (Fig. 5.5d).
48