Mounting Of Wall Bracket And Installation Of Q-Tee Wall - attika RAIS Q-Tee Bedienungsanleitung

English All manuals and user guides at all-guides.com RAIS - Manual for RAIS Q-Tee

Mounting of wall bracket and installation of Q-Tee Wall

The stove can only be mounted on non-combustible walls without cracks. Contact the
chimney sweep or building expert regarding the wall's suitability. RAIS recommends that
hanging and installation of RAIS Q-TEE WALL should only be done by authorized dealers.
Remove the knock-outs for the wall bracket (1) and
1
chimney (2) at rear of the stove (see section 'Change
of chimney connection'). Remove he blanking plate
and the packing and mount them on the stove top
outlet - please ensure that the gasket is properly
2
seated. Parts are screwed together with 3 M6 bolts.
The wall bracket (3) is centered in relation
to wall pipe in the wall or at the desired
distance above the floor.
The holes are marked up through the holes
4 3
in the bracket. All holes are drilled, a mini-
mum of 2 holes must be in a brick.
The bracket is mounted with screws suitable
to the type of wall. The bracket's upper edge
should be horizontal. Note that the screw
head is not higher than 11mm. Plastic plugs
are not permitted. Bolts and other fastening
material are not included in the delivery from
RAIS.
The flue (4) with the seal is mounted on the
back of the stove with 3 M6 screws instead
of the blanking plate.
Distance from wall to center of chimney is 141.5mm.

18