Flex WB 110-260 Originalbetriebsanleitung Seite 16

– The manufacturer logo must face toward the
front so that it can be read.
– Ensure that the saw stand is stable and that
all locking pins have engaged.
Mounting the Work Stop and the
Work Support (see figures D)
– Screw the work stop (3) to the work support
(6) with carriage bolt M8 x 60
locking knob (2).
– Insert the work support (6) into the extension
rail (4).
– Tighten the locking knob (1) to lock the work
support. Repeat the steps with the other
work support.
Attaching the Miter Saw to Saw
Mounting Brackets (see figure E)
WARNING!
Remove the battery pack from the miter saw
before mounting the miter saw to the miter saw
stand.
– Position the miter saw to achieve maximum
balance and stability.
– Place the spring washers (17) and the flat
washers (18) onto the hexagon socket head
bolts (16).
– Lift one side of the saw and place a saw
mounting bracket underneath, aligning the
bolts (16) with the sliding plates (E-1) in the
slot of the saw mounting bracket through
the Miter Saw mounting holes.
– Lower the saw onto the bracket, securing the
bolts (16) into the sliding plates (E-1).
– Repeat above steps to install the second
bracket to the other side of the saw.
– After making sure that both brackets are
parallel to each other, finger tighten all four
bolts to hold the Miter Saw in position. The
bolts will be completely tightened after the
saw is mounted to the stand.
NOTE
The mounting bracket locking levers should
face the operator when assembling the saw
mounting bracket with the Miter Saw.
Universal Miter Saw Mounting
Method
Use 19mm Plywood to Mount
Your Miter Saw (see figures F)
16
M8 x 60 and work stop
– Determine the correct size of plywood
needed. The plywood must be at least
101.6mm wider than the largest width of
your Miter Saw base. The plywood should be
at least as deep as the smallest depth of the
Miter Saw base or a minimum of 406.4mm if
the Miter Saw base is smaller. Make sure that
the plywood is square.
– Drill 9.5mm holes 25.4mm from the front
two corners of the plywood, 381mm apart
and 25.4mm from the sides. As shown in
Figure Fa.
– Place the plywood on top of the mounting
brackets and align the drilled holes with the
slots in the mounting brackets.
– Mount the plywood to the mounting
brackets as described in the "Attaching Saw
to Saw Mounting Brackets" section.
– Place the Miter Saw on top of the plywood
in the correct location and mark the location
of the Miter Saw mounting holes to the
plywood.
– Drill holes according to the size of the
hardware chosen:
■ The hardware diameter is determined
by the mounting holes in the Miter Saw.
■ The length of the hardware must be
31.8mm longer than the maximum
height of the Miter Saw base at each of
the four mounting locations.
■ Hardware must be minimum of Grade
5 or Class 8.8.
– Secure the Miter Saw to the plywood as
shown in Figure Fb.
M M ounting the Miter Saw to the
Stand
Mounting Bracket Locking Lever
(see figures G)
To unlock the mounting bracket locking
lever:
Pull the safety buckle (G-1) towards the
locking lever (9). Hold them together and pull
them out to disengage the lock.
To lock the mounting bracket locking lever:
Press down the locking lever to engage the
lock.
Mounting the Miter Saw to the
Stand (see figures H)
– Lift the saw and bracket assembly, hook the
WB 110-260