Single Measurements; Continuous Measurement; Measuring Volumes - Hilti PD-I Bedienungsanleitung

All manuals and user guides at all-guides.com

5.6 Single measurements

1. Press the "Measure" button briefly to activate the laser beam.
2. Keep the laser beam on the target point.
3. Press the "Measure" button briefly to take the measurement.
◁ The measured distance is shown in the lower line of the display.
◁ The distance measured in the previous measurement is shown in the upper line of the display.
4. To take another measurement, keep the laser beam on the target point and press the "Measure" button
again.

5.7 Continuous measurement

Note
During continuous measurement, 6-10 measurements are taken and displayed every second. The
laser range meter can be moved relative to the target until the desired distance is reached.
1. Press the "Measure" button for 2 seconds.
◁ If the signal tone is active, a signal tone will be emitted.
2. Move the laser range meter toward or away from the target until the desired distance is reached.
3. Press the "Measure" button briefly.
◁ The measured distance is shown in the lower line of the display.
◁ The distance measured in the previous measurement is shown in the upper line of the display.

5.8 Measuring volumes

1. Aim the tool at the target point and press the "Measure" button.
2. Aim the tool at the next target point and press the "Measure" button.
3. Aim the tool at the next target point and press the "Measure" button.
5.9 Measuring rectangular areas
1. Aim the tool at the target point for the room width and press the "Measure" button.
2. Aim the tool at the target point for the room length and press the "Measure" button.
5.10 Layout function
1. Enter the distance manually. Do this by using the left or right arrow buttons to select the keyboard symbol
and confirm by pressing the "Measure" button.
2. Select the applicable numbers and confirm by pressing the "Measure" button.
3. To confirm the value, select the check mark symbol (tick) at the bottom right corner.
4. Select the flag symbol.
◁ The distance you have entered will then be shown between the two flags.
5. Press the "Measure" button to begin measuring.
◁ The arrows on the screen indicate in which direction you must move the tool. When the target
distance is reached, black arrows appear above and below the distance shown in the display.
6. To repeat this distance measurement several times, move the tool further. The number of times you have
measured out this distance is shown on the right of the screen.
7. Press the "Measure" button to stop measuring.
Note
When the distance to be set out is reached, the currently used measuring reference is shown in
the display.
Note
As an alternative to entering the distance manually, the distance to be set out may also be
measured with the tool. To do this, select the symbol for single measurement and confirm your
choice by pressing the "Measure" button.
18