Bose PackLite A1 Bedienungsanleitung Seite 8

Svenska Nederlands
All manuals and user guides at all-guides.com
P L TM P A
ACK ITE OWER MPLIFIER
Figure 4
Typical setup
INPUT
OUTPUT
A1 amplifier
B1 bass
modules
CAUTION:
A1 amplifier.
CAUTION:
module that is already connected to the Amp 3 OUT connector of
a PS1 power stand, or to another A1 amplifier.
Note:
recommended. Using balanced cabling prevents common
interconnect noise problems.
Note:
stacked in a column. Stacking may improve acoustic output.
Using multiple A1 amplifiers together
To add more bass capability to your system, you can connect
multiple A1 amplifiers as shown in Figure 5 on page 9.
1. Connect the AC power cord to an AC (mains) outlet.
2. Make sure the Power switch is OFF.
3. Using the supplied ¼" TRS cable, connect the Bass-Line
OUT connector on the PS1 power stand to the INPUT
connector on the first A1 amplifier.
8
Italiano Français Español
M A1
ODEL
PS1 power stand
Do not connect more than two B1 bass modules to an
Be careful not to connect the A1 amplifier to a B1 bass
Using the supplied ¼" TRS cable with your A1 amplifier is
Up to four (maximum) B1 bass modules can be
Deutsch Dansk
Bass-Line
OUT
B1 bass
modules
English