Home Connect; Setting Up Home Connect; Checking The Signal Strength - Bosch KGB Serie Beiblatt

Home Connect
1 Home Connect
This appliance is network-capable.
Home Connect
Connect your appliance to a mobile
device to control its functions via the
Home Connect app.
The Home Connect services are not
available in every country. The avail-
ability of the Home Connect function
depends on the availability of
Home Connect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use Home Connect,
you must first set up the connection
to the WLAN home network (Wi-Fi)
and to the Home Connect app.
After switching on the appliance, wait
at least 2 minutes until internal
device initialisation is complete. Only
then should you set up Home Con-
nect.
The Home Connect app guides you
through the entire login process. Fol-
low the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents sup-
plied by Home Connect.
¡ Please also follow the instructions
in the Home Connect app.
Notes
¡ Please note the safety precautions
in this instruction manual and
make sure that they are also ob-
served when operating the appli-
ance via the Home Connect app.
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
Home Connect app.
1.1 Setting up Home Connect
Requirement: The Home Con-
nect app has been installed on your
mobile device.
Scan the QR code using the
1.
Home Connect app.
Follow the instructions in the
2.
Home Connect app.
1.2 Checking the signal
strength
You should check the signal strength
if no connection could be estab-
lished.
Press +
1.
same time.
a The temperature display (refriger-
ator compartment) shows
Press repeatedly until the tem-
2.
perature display (refrigerator com-
partment) shows .
a The temperature display (freezer
compartment) shows a value
between (no reception) and
reception).
Note: The signal strength should be
at least .
Improving the reception
If the signal strength is too weak, the
connection may be interrupted.
Carry out one of the solution op-
▶
tions:
Home Connect en
at the
.
(full
27