Radio Connection; Ir Connection - Grundfos MI 301 Montage- Und Betriebsanleitung

4. The blue LED is flashing until your smartphone is connected.
Once the connection is established, the LED starts to flash
green.
5. MI 301 is now ready to establish a connection to a Grundfos
product. Keep MI 301 within range of the Grundfos product you
want to connect to.

4.3 Radio connection

Radio - List and Radio - Connect are methods for radio
communication between Grundfos GO Remote and a Grundfos
product.
Check the section concerning supported Grundfos products to see
if your Grundfos product is supported.
Use Radio - List for products that are difficult to access physically
or for a quick status overview. You must unlock the Grundfos
product when you connect to it for the first time. A padlock shows
whether the product is locked or unlocked.
Use Radio - Connect for quick and direct access to the product.
The Grundfos product is locked.
The Grundfos product is unlocked.
Related information
2.4 Supported Grundfos products
4.2 Grundfos GO Remote
4.3.1 Connecting to a product using Radio - List
4.3.2 Connecting to a product using Radio - Connect
4.5 Signalling communication with remote control
6.3 MI 301 cannot connect via radio
4.3.1 Connecting to a product using Radio - List
Follow this procedure to unlock and connect to a product:
1. Press List next to Radio.
2. All products within radio range are listed. It may take some time
to scan for all products.
3. The list shows the product name, pump status, signal strength
and whether the product is locked or unlocked.
4. Use the wink command to identify the product you have
selected. When you press the symbol, an indicator light will flash
on the product. See the section concerning signalling
communication with remote control. Press the symbol again to
stop the wink.
Wink symbol
5. Press the product name to connect to the product.
6. If the product is locked, press OK or a dedicated connection
button on the product.
7. Data is loading. It may take some time.
8. A connection has been established, and Grundfos GO Remote
shows the product dashboard.
9. Press Disconnect to disconnect the product and connect to
another one.
Related information
4.3 Radio connection
4.3.2 Connecting to a product using Radio - Connect
Follow this procedure to establish connection:
1. Press Connect next to Radio.
2. The indicator light in the centre of the Grundfos Eye is flashing
on all supported products within range. Press OK or a dedicated
connection button on the product you want to connect to.
3. Data is loading. It may take some time.
4. A connection is established, and Grundfos GO Remote shows
the product dashboard.
5. Press Disconnect to disconnect the product and connect to
another one.
Related information
4.3 Radio connection

4.4 IR connection

IR - Connect is a method of infra-red communication with the
Grundfos product.
Related information
4.2 Grundfos GO Remote
4.5 Signalling communication with remote control
6.2 MI 301 cannot connect via infrared (IR)
4.4.1 Connecting to a product using IR - Connect
Follow this procedure to establish connection:
The infrared transmitter is located at the opposite end of
MI 301 from the power button
1. Point the infrared transmitter on MI 301 at the infrared receiver
on the Grundfos product. The distance must not be more than 1
metre.
2. Press Connect next to IR.
MI 301 is connecting to the Grundfos product via IR.
Data is loading. This may take some time.
3. Hold MI 301 steady until all data have been read. An indicator
light on the product flashes when the product is communicating
via IR.
When the connection is established, Grundfos GO Remote
shows the product dashboard.
4. Press Disconnect to disconnect the product and connect to
another one.
9