Gens Ace Imars III Pro Bedienungsanleitung Seite 22

Battery
interface no
Loading/low
5
voltage/short
circuit
protection
Can not
6
work
Battery
7
Voltage
Error
Thank you for purchasing this product. If you have any problems with
this charger. Please discontinue any further use and contact your local
distributor immediately.
This product is warranted to be free from manufacturer defects for 1 year
from original purchase date. Please keep your original proof of purchase
for warranty purposes.
What is not covered by the warranty
1.Failure to use correct input voltage(100-240VAC)
2.Failure to follow instruction manual
3.Mechanical damage due to external causes
4.Disassembly,modification by the user(modifying original connectors,wires,compo-
nents,etc.)
5.Use in improper conditions(damage or rust from rain,humidity,etc.)
6.Normal wear and tear surface shell,dents and scratches Gens Ace is not responsible for
the abuse or misuse of this product.
7.We reserve the sole right to modify this manual at any time without notice.
Grepow Inc.
Tel: 925 364 7166
Fax: +1-925-364-7177
Email: info@genstattu.com
Gens Ace ImarsIII
WARRANTY
22
1.Click the button of Back /Stop to exit the error
status.
2. Check the battery interface port is without loading:
check the if there is poor contact in the charger
interface with battery
-Battery interface (main
3.Check whether the battery is over discharge,(the
port) no Loading
total voltage ≤2.5V).Use the charger
-Battery interface (main
function"PROGRAM SELECT LI BATT METER" to
read every cell 's voltage. If the total voltage is lower
port) low voltage(≤2.5V)
than 2.5V, it is over discharge and suggest to charge
-Battery interface (main
before use.
port) short circuit
3.Check whether the battery is short circuit.
protection
Pull out the battery, and use the multimeter to test the
battery ,checking whether it is short circuit. If yes,
please do not use the battery.
4.If you have check the 2/3/4, and the error is not
solved，please contact the professional for checking
and maintaining.
circuit failure
When the charger
1. Select "PROGRAM SELECT→ LI BATT
detected that the cell
METER" to read the voltage of a single cell. If
voltage difference meet
the voltage meets the abnormal trigger
the following conditions,
condition, it means that the battery is faulty
it will trigger a battery
(the voltage is too low or the voltage
voltage abnormal alarm:
difference is too large). It is recommended to
LiPo/LiHV: Single cell
stop using the battery and discard it;
voltage <2.8V, voltage
2. If the displayed voltage of "PROGRAM
difference △V>400mV;
SELECT→ LI BATT METER" does not match
LiFe: Single cell voltage
the actual battery voltage, check the balance
<1.0V, voltage
port line against the voltage to see if there is
difference △V>500mV;
a bad contact or break.
Please unplug the AC plug for 30 second
before inserting.