Gens Ace Imars III Pro Bedienungsanleitung Seite 17

Press the Back/Stop
button
LiHV
Discharge completed
After the discharge is complete, the screen will cycle through the three displays to show the
discharge completion mode, discharge time and discharge capacity:
(1) Normal mode discharge
completion display
Tips: When the charger is in CHARGE/CellBAL/STORAGE/DISCHG operation, you can
press the "+/-" button to check the single battery voltage, the cutoff voltage, the working time,
and the working capacity. To return to the main display screen press the Enter/Start button;
Long press the Enter/Start
button for 2S
Press the Enter/Start button
LiPo/Life/NiMH
Press the Enter/Start button again;
(LiHV battery only)
(2) Timeout Cut-Off mode
discharge completion
display
Select the battery chemistry, mode,
cell count , amperage and other
parameter settings (see details in 1.1
for parameter setting operation) to
ensure that the parameters match the
actual battery;
Long press the Enter/Start button for
about 2 seconds to enter a
confirmation display (the two display
on the left side cycle flash)Press the
Enter/Start button briefly again to start
the charger, or Press the Back/Stop
button to return to the previous menu;
From the confirmation screen,
(1) If the battery model is
LiPo/LiFe/NiMH, press the Enter/Start
button (to prevent misoperation) and
turn on the discharge;
(2) If the battery type is LiHV battery,
press the Enter/Start button to enter
the secondary confirmation screen;
If the battery type is LiHV battery, after
entering the secondary confirmation
screen, press the Enter/Start button
again to confirm and start the
discharge;
(3) Capacity Cut-Off mode
discharge completion
display
Gens Ace ImarsIII
17