Klarstein KAMINI FXL 2G Bedienungsanleitung Seite 21

EN
When you press the heating button on the remote control, the
heating function will start at a high level. "0H" is displayed in the
display window. If you press the heat button again, the appliance will
switch to the low heat level. "OL" is displayed on the screen. If you
press the heating button again, the heating function will be switched
off. The fan will then continue to run for 60 seconds to disperse the
heat remaining in the unit.
In standby mode, the flame effect is disabled by default. When you
press the flame button, the charcoal set will be illuminated and will
flicker automatically. The flame effect is set to the brightest mode and
'05' is displayed in the display window.
When you press the flame button again, the flame brightness will
be lowered by one level and '04' is displayed in the display window.
By pressing the flame button several times, the brightness will be
lowered one level at a time in the following sequence: 05 - 04 - 03 - 02
- 01 - Off - 05 ... .
The flame effect can be adjusted separately. The display window
shows the level 01, 02, 03, 04 or 05.
Temperature setting:
Press the heat button on the remote control. Then press the + and -
buttons to adjust to the desired temperature. The temperature can be
set between 15 °C and 30 °C.
21