Maintenance - Jotul SCAN Andersen 4 Montage- Und Bedienungsanleitung

ENGLISH
6.2 Replacing the burn plates/inner
bottom
Fig. 17
2
1. Take out the baffle/exhaust deflector (see 6.1 - Replacing the
baffle/exhaust deflectors)
2. Take out the side burn plates (Fig. 17 - 1).
3. Take out the rear burn plates (Fig. 17 - 2).
Fig. 18
1
4. Lift out the ash grate (Fig. 18 - 1) and inner bottom plate
(Fig. 18 - 2).
5. When refitting, follow the same procedure in reverse order.
42
All manuals and user guides at all-guides.com

7.0 Maintenance

7.1 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fireplace during use. Soot is a good insulator and will therefore
reduce the fireplace's heat output. If soot deposits accumulate
when using the product, they can easily be removed by using a
soot remover.
1
In order to prevent a layer of water and tar from forming in the
fireplace, you should regularly allow the fire to burn hot in order
to remove the layer. Your product should be cleaned internally
once a year to ensure the best heating effect. It is a good idea to
do this when cleaning the chimney and flue pipes.
7.2 Sweeping the flue pipe to the
chimney
Flue pipes must be swept through the flue pipe sweeping hatch
or through the door opening. The baffle and exhaust deflectors
must be removed first.
7.3 Cleaning the glass
The product is equipped with an air wash for the glass. Air is
sucked in through the air vent on the top of the product and
down along the inside of the glass.
However, some soot will always stick to the glass, but the quantity
will depend on the local draught conditions and adjustment of
2
the air vent. Most of the soot layer will normally be burned off
when the air vent is opened all the way and a fire is burning
briskly in the fireplace.
Good advice! For normal cleaning, moisten a paper towel with
warm water and add some ash from the burn chamber. Rub it over
the glass and then clean the glass with clean water. Dry well. If it
is necessary to clean the glass more thoroughly we recommend
using a glass cleaner (follow the instructions on the bottle).
7.4 Inspection of the fireplace
We recommend that you carefully inspect your fireplace yourself
after it has been swept/cleaned. Check all visible surfaces for
cracks. Also check that all joints are sealed and that the gaskets
are in the correct position. Any gaskets showing signs of wear or
deformation must be replaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(available from your local Scan dealer) and press the gasket well
into place. The joint will dry quickly.
7.5 Exterior maintenance
Painted products may change colour after they have been used
for several years. The surface should be cleaned and brushed free
of any loose particles before new paint is applied.