Electrical Connection; Final Mounting - Maico ECA 100 ipro RC Montage- Und Betriebsanleitung

8 Installation and commissioning
7. Insert housing into wall breakthrough/wall
sleeve and secure with two screws. Do not in-
sert the housing such that it is twisted or
crushed. Make sure you use mounting mater-
ial which is sized for the purpose.

8.3 Electrical connection

NOTICE Risk of damage to unit in the event of
short-circuits.
Insulate PE conductor and individual cable cores
that are not required.
Do not touch electric components.
1. Only lay single cable cores in the fan. To do
this, remove power cable sheathing over a
length of 90 mm. Strip single cable cores to 9
to 10 mm.
11 Spring clip
12 Connection wiring diagram
2. Connect power cable to the spring clip → Wir-
ing diagrams [} 50].
3. Check position of cable grommet. It must be
well sealed.

8.4 Final mounting

NOTICE Danger of short-circuits and damage
to the unit. Humidity will penetrate if electron-
ics cover is not fitted correctly.
Press electronics cover firmly onto housing such
that it is sealed and flush all the way around.
When doing so, do not press setting buttons.
26
10 Setting button
1. Push the electronic cover on the housing cut-
outs I, II and III onto the 3 locking tabs, until
the tabs engage. In addition, press the elec-
tronics cover firmly onto the housing at both
points indicated by the word PRESS.
2. With RCH unit models, plug the supplied
sensor (→ arrow X) into the connector sock-
ets.
RCH: Do not touch/push on the membrane on
the flat side of the sensor wall, otherwise it will be
damaged.
3. Attach housing cover.
4. Teach-in the radio components with the left
setting button → Tips for teaching-in radio
components [} 27].