Quax COCOON 54F01-0400 XL Serie Bauanleitung Seite 38

Step 4.8 : Use the parts from step 4.4 and step 4.5, the construction from step 4.7, sixteen wood screws D and six legs M.
Place the bottom (4) in front of the drillings in the end and intermediate sides. Push eight wood screws (D) into the holes
at the underside of the bottom and tighten them in the sides. Tighten the legs (M) in the bottom mounting plates. Place
the top (5) in front of the drillings in the end and intermediate sides. Push eight wood screws (D) into the holes at the up-
perside of the top and tighten them in the sides.
Quax nv Karel Picquélaan 84 B-9800 Deinze Belgium T
COCOON 54F01-0400xXL
T 0032 9 380 80 95
Step 4.9 : Use the construction from
step 4.8, three backs 18, fourteen panel
clamps J and forty-nine wood screws I.
Place the backs (18) in the cut-outs of the
top, bottom and end sides. Check if both
angular distances are the same. Con-
nect the back at the height of the inter-
mediate sides with the panel clamps (J).
Push a wood screw (I) into the clamps
and tighten in the intermediate sides. At-
tach the backs to the end sides, bottom
and top using thirty-fi ve wood screws (I).
38
www.quax.eu - E E info@quax.eu