Quax COCOON 54F01-0400 XL Serie Bauanleitung Seite 35

4. Assembling the wardrobe
Step 4.2 : Use the right intermediate side 3R, four wooden
dowels E, a slider L, nine wood screws A, two push systems
H, four wood screws I, two rod holders S, eight shelf supports
T and four hinge mounting plates R
Push two wooden dowels (E) into the drillings at the top and
bottom of the intermediate side (3R). Disassemble the slider
(L). Place the outer slider on the holes on the left side of the
intermediate side. Attach the slider with fi ve wood screws (A).
Note the detail. Disassemble the push systems (H) Place the
mounting plates with the lip
on the drillings above and under the slider. Attach the mounting
plate with two wood screws (I). Push the systems back onto
their holders. Push two shelf holders (T) into the drillings on the
left side of the intermediate side. Push six shelf holders (T) into
the drillings on the right side of the intermediate side. Place the
rod holders (S) on the drillings in the middle of the right side of
the intermediate panel. Attach the holder with two wood screws
(A). Push the four hinge mounting plates (R) into the holes on
the left side of the intermediate panel.
Quax nv Karel Picquélaan 84 B-9800 Deinze Belgium T
COCOON 54F01-0400xXL
(see red arrow) facing backward,
T 0032 9 380 80 95
Step 4.1 : Use the left side 1, the right side 2, eight
wooden dowels E, four connectors F, six hinge moun-
ting plates R, four rod holders S, eight wood screws A
and twelve shelf supports T
Tighten the connectors (F) in the drillings on top of the
sides (1 and 2). Push two wooden dowels (E) into the
holes at the top and bottom of the sides. Push three
hinge mounting plates (R) into the holes at the front of
the left side. Push three hinge plates (R) into the dril-
lings at the front of the right side. Place the rod holders
(S) on the drillings in the middle of the sides. Attach the
supports with two wood screws (A). Push the shelf sup-
ports (T) into the holes of the sides.
35
www.quax.eu - E E info@quax.eu