EuroLite LED Space Ball 35 Bedienungsanleitung Seite 23

Operating conditions
Switch on the hoist only if the Space Ball is installed.
Switch on the hoist in a vertical position only.
The built-in winch system automatically resets with each start. When the hoist has not been installed in
a vertical position or the Space Ball has not been installed, the cable could get entangled, causing
damage to the winch system and rendering the warranty void.
Start-up sequence
Before switching on the hoist always make sure that:
• the hoist has been installed in a vertical position.
• the Space Ball has been installed and secured by means of the carabiner.
• the hoist rope is not loose.
• nothing hinders the hoist's movement.
Setting the DMX starting address
To be able to operate the hoist with a DMX controller, the DMX starting address must be set. The starting address
depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the MENU button to indicate the first menu item Addr. Confirm with ENTER.
2 Use the buttons ▲ and ▼ to set the address and confirm with ENTER. The display shortly inserts SAVE.
Note: Please make sure you do not have any overlapping channels in order to control each device correctly and
independently from any other fixture in the DMX chain. If several devices are addressed similarly, they work
synchronously.
Functions in DMX mode
Channel Value
1 000-255
2 000-255
3 000-255
4 000-255
000-009
010-019
5
020-209
210-255
6
001-255
7 000-255
001-239
8
240-245
246-255
Function
Brightness Red
Brightness Green
Brightness Blue
Overall brightness
Blackout
No function
Strobe effect
No function
000 Winch locked
Hoist
Hoisting speed
000 Winch locked
Unlock winch
Reset winch
Unlock winch
OPERATION
WARNING!
WARNING!
Description
Increasing speed
When channel 8 is set to value 0
From top to bottom
Decreasing speed
When channel 6 is set to value 0
Unlock winch before using channel 6
Resetting the winch to the starting position twice
ensures an accurate result: Automatically by
switching on the hoist and with channel 8.
23 • EN