Installation Of The Appliance; Installation Safety - Sharp KH-9I39CS00-EU Bedienungsanleitung

· Use a special ceramic hob cleaner
on the hob while it is warm to touch.
Rinse and wipe dry with a clean cloth
or paper towel.
INSTALLATION OF THE
APPLIANCE
WARNING:
The electrical connection of this hob
should be carried out by a qualified
electrician, according to the instructions
in this guide and in compliance with
the current regulations. In the event
of any damage that occurs as a result
of improper connection or installation,
the warranty will not be valid. This
appliance must be grounded.

Installation safety

· Any overhanging surface should be at
least 65cm above the hob.
· Extractor fans must be fitted in
accordance with the manufacturer's
instructions.
· The wall in contact with the rear of
the hob must be made of flameproof
material.
· The power cable length should not
exceed 2 metres.
Fitting the hob into a work
surface
· The hob can be inserted into any
worktop provided it is heat resistant up
to at least 90ºC.
· Create an opening with the
dimensions shown in the picture below
and on the next page.
· The induction hob may be built in 25
to 40 mm thick worktops.
W (mm)
D (mm)
H (mm)
C1 (mm)
C2 (mm)
I (mm)
EN
min. A (mm)
890
520 min. B (mm)
56 E (mm)
860 min. F (mm)
490 G (mm)
J (mm)
38
50
50
10
10
20
5