auna Buddy Bedienungsanleitung Seite 38

EN
38
To carry out an auto tune:
1. Press hold the Menu Button for 2 seconds to view the main menu.
2. Turn and press the Select dial to choose 'Full Scan'. The number of
stations found will be displayed during the auto tune.
When the auto tune has finished, will tune to the last station that you were
listening to. If the last station you were listening to is no longer available,
will tune into the first station in the alphabetical list.
Manual tuning
To manually check the signal strength of a known channel:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'Manual tune'.
3. Turn and press the Select dial to choose the channel.
Dynamic range control
Dynamic Range Control (DRC) is used to make quieter sounds in a digital
radio broadcast easier to hear at low volume or in a noisy environment.
Check with the broadcasters to find out if they use DRC.
To change the DRC settings:
1. Press the Menu button.
2. Turn and press the Select dial to choose 'DRC'.
3. Turn and press the Select dial to choose between one of the following
options:
• DRC high: Applies maximum compression to the DRC level.
• DRC low: Applies reduced compression to the DRC level.
• DRC off: Removes DRC compression.
FM radio settings
Note: You can only see the FM radio settings when you have selected 'FM'
as the radio source.
FM stereo option
You can choose between stereo or mono reception when listening to FM
radio. Mono may improve
clarity where stereo signals are weak.
To change between Stereo or Mono reception:
1. Press hold the Menu Button for 2 seconds to view the main menu.
2. Turn and press the Select dial to choose 'Audio Setting'.