EINHELL BH 2000-1 Originalbetriebsanleitung Seite 9

Anleitung_BH_2000_1_SPK7__ 11.04.14 08:19 Seite 9
Danger!
Read all the safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Heat output switch
2. Thermostat control
3. Operating status indicator
4. Air outlet
3. Items supplied
Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys! Do not let children play with plastic bags,
foils or small parts! There is a danger of
swallowing or suffocating!
Bath heater
n
Assembly material
n
Original operating instructions
n
4. Intended use
The equipment is designed for use as a wall-mounted
heater in the bathroom, WC, cellar, hobby room etc.
Use the equipment only to heat room air in enclosed
rooms.
The equipment may be used only for its intended
purpose. Any other use is deemed to be a case of
misuse. The user/operator and not the manufacturer
will be liable for any damage or injuries of any kind
which result from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data:
Rated voltage:
Heat output:
Thermostat control:
Protection class:
Protection type:
6. Before starting the equipment
Wall-mounting
Caution!
The equipment is allowed to be mounted only on a
wall. The minimum clearances must be observed.
The equipment is allowed to be used only when it is
completely assembled and in a vertical position.
Ensure that a minimum clearance of 40 cm to the
sides, 80 cm to the ceiling, 110 cm to the floor and
100 cm to the front of the housing are maintained.
Observe point 1 - Safety information.
Caution! Make sure that there are no electric cables
or other installations (for example water pipes) near
the drill holes. Ensure that the equipment is secured
firmly and horizontally to the wall. Use only suitable
fastening material on a wall capable of bearing the
load. The supplied dowels and screws are suitable for
the following: concrete, natural stone with a dense
structure, solid brick, solid limestone bricks, solid
lightweight concrete bricks and aerated concrete.
Mark the position of the drilled holes (diameter
6 mm, height from the floor at least 145 cm) for
mounting the equipment on the wall.
Note: The drill holes are arranged 170 in apart
horizontally.
Then drill the holes in the wall, insert the dowels
and drive in the screws. The distance between
the screw head and the wall should be approx. 3
mm.
Hang the heater on the screws in the wall. Push
the heater to the left as far as the stop and pull
it down as far as the stop. The heater is now
mounted on the wall.
GB
230 V ~ 50 Hz
2000 W
Infinitely adjustable
II
IP 24
9