What If There Are Problems; Replacement Parts And Wearing Parts; Technical Data - Beurer ELLE MPE 58 Gebrauchsanweisung

6. What if there are problems?

Problem
Device will not switch
on.
UV nail gel does not dry. Treatment time with UV light too short. Set a longer UV light treatment time.
Nail varnish does not
dry.
UV fluorescent tube
does not light up.

7. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding service address (according to the
service address list). Please state the corresponding order number.
Designation
UV fluorescent tubes, 4 units
8. Disposal
Observe the local regulations for material disposal. Dispose of the unit in accordance with EC Directive
2002/96/EC – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please
contact the local authorities responsible for waste disposal.

9. Technical data

Model no.
Dimensions
Weight
Power supply
Nominal power
Permissible storage conditions
Number of UV lamps
UV lamp type
UV type of device
Switch-off times
Possible cause
Mains plug not plugged in.
No voltage at mains socket.
Treatment time in dryer too short.
UV fluorescent tube not correctly
inserted.
UV fluorescent tube faulty.
Item number and/or order number
163.290
MPE 58
L 220 x W 210 x H 100 mm
1632 g
220 – 240 V, ~ 50/60 Hz
40 W
Store in a clean and dry place
4
UV-9 W-L 365 nm, 9 W
UV-A lamp type 3
90 seconds, 120 seconds, continuous operation
Solution
Insert the mains plug into the socket.
Check your fusebox.
Keep your varnished nails in the dryer for
longer.
Check that the UV fluorescent tube has
been correctly inserted.
Insert a new UV fluorescent tube.
12